I would check (replace) the temperature sensor before I messed with the guage.
al
---- Joe Merone <jmerone@rocketmail.com> wrote:
> The temperature gauge on my TR6 is the one instrument that has worked without
> much deviation or any failure for years - until now. The normal operating
> temperature usually reads slightly below the 1/2 mark, but for the past week
> it wouldn't go up over the 1/4 mark. Now nothing - it won't budge off the
> bottom. I've fiddled around behind the dash to make sure that everything is
> connected, and traced the wire up to the sensor near the thermostat. I think
> that it all seems where it's supposed to be. Any ideas? Do these things just
> die? I did replace the voltage stabilizer last year when it was on the fritz,
> but don't know if there's any connection.
>
> Thanks in advance.
>
> Joe Merone
> South Burlington, VT
> CF18928
>
> Just back from The Glen
> 4 nights with the wife
> in a tent!
> 850 miles r/t
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|