> Anyone have any suggestions as to how to remove the old
> pins?
Only the obvious ones of vice grips, etc. The original pins are usually
soft enough that you can drill and tap them (as a last resort), but if
someone has replaced them with aftermarket pins, they may be too hard for
that.
> Am assuming one can purchase drill rod in the right diameter and cut to
> proper length for replacements?
That will work, although you can also buy ready-made pins.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|