Hey Dan,
I learned all about locating dowels this winter! Drill rod works or you can
buy the dowels pretty cheap at McMaster. Here's the page I did on them and
the McMaster part # for the tranny dowel is on the page
http://tr6.danielsonfamily.org/LocatingDowels.htm
Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
http://tr6.danielsonfamily.org
-----Original Message-----
From: triumphs-bounces+75tr6=tr6.danielsonfamily.org@autox.team.net
[mailto:triumphs-bounces+75tr6=tr6.danielsonfamily.org@autox.team.net] On
Behalf Of A Daniel Cronin
Sent: Tuesday, July 15, 2008 1:04 PM
To: Triumph List
Subject: [TR] Locating dowel pins
Am in the process of complete motor, trans rebuild, etc and am desirous of
making sure all the "mating" surfaces (front motor plate, cylinder head @
intake/exhaust, bell housing, crank flywheel flange, etc) are true and would
like to remove the various locating dowel pins so the job is properly
accomplished. Anyone have any suggestions as to how to remove the old pins?
Am assuming one can purchase drill rod in the right diameter and cut to
proper length for replacements?
Thanks for any input you can provide.
Dan
Planning &
Development Services
A. Daniel Cronin
248 761-2673
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as 75tr6@tr6.danielsonfamily.org
http://www.team.net/archive
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.138 / Virus Database: 270.4.10/1552 - Release Date: 7/14/2008
6:28 PM
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|