In a message dated 6/10/2008 6:13:51 PM Central Daylight Time,
yellowtr@adelphia.net writes:
> I just finished tightening the 2 bolts/nuts that hold the right rear shock.
>
> I would like to use a socket wrench but my sockets all are too big to fit
> that
> small area.
>
>
I don't know which car you have but the clearances on the TR3 shock are so
tight, I switched to socket head bolts where I can use an allen wrench.
Otherwise check Sears of the usual tool outlets.
Dave
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|