On Tue, 13 May 2008 triumph@2simpleusa.com wrote:
> My block is going in to be prepared for insertion of Spit. cam bearings
> ... does anyone have the definitive bore size for fitting the Spitfire
> cam bearings in te TR6 block?
If you provide the bearings with the block, any competent machinist will
figure out what to do. Otherwise, if you tell them that the bearings are
from a Spitfire, they can look up the OD for the align bore.
Don't forget to provide your cam so they can dimension the journals for
proper clearance. Otherwise, they might go in too tight and you'll have
problems.
I recall that aptfast.com had the dimensions, but I'm having trouble
accessing that site right now... but check them out.
> Thanks,
> **************
> Tony Gordon
> 72 TR6
> **************
rml
---------------------------------------------------------------------------
Bob Lang NER/SCCA | This space for rent
Solo Chair 2008 TR6 40 F Prepared | Triumph!
Voice:781-438-2568 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|