Better yet, pull them apart, clean them, slip an inch and a half of
heat shrink tubing over the wire, reconnect and shrink the tube to
seal the joint. Do as needed or as you have the energy.
On 7-Apr-08, at 12:00 PM, triumphs-request@autox.team.net wrote:
>
> From: Bill & AnnaBelle <anabil007@comcast.net>
> Date: April 7, 2008 10:50:17 AM MDT (CA)
> To: TeriAnn Wakeman <twakeman@razzolink.com>, triumphs@autox.team.net
> Subject: Re: [TR] Lucas's looseness limits lighting?
>
>
> Wouldn't it be simpler, and more efficient in the long run to
> just replace those lousy bullets with modern insulated spade
> connectors? You wouldn't have to do it all at once, just replace
> the bad ones as they failed, or pulled apart, broke, burned, gave
> up, or just plain did not work.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|