Good morning List,
Now that I have a stripped rolling chassis I have been look carefully at the
front suspension. It was completely re-built by the PO and looks to be very
solid with the exception of the upper wishbone bushings. One is obviously
loose so I will replace both sides while I am at it.
My question is this: Can I simply remove the castellated nut at the
junction of the wishbones the pull the upper fulcrum pin and do the
replacement on the bench? Being as there is no weight on the suspension, is
anything under tension or do I need to compress the road springs before
removing the wishbone units?
Thanks,
Bill B
'58 TR-3A TS/30766 L
'59 TR-3A TS/64974 LO
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|