Bob, when I put the TR4 OD in my TR3A, I removed the cross member, drilled 2
new holes next to the existing holes, (in front or behind, can't remember)
and then used a cutoff wheel on my Dremel to join the new and old holes to
make them slots. Worked for me.
Bob
----- Original Message -----
From: "Bob Labuz" <yellowtr@adelphia.net>
To: "Triumph Email List" <triumphs@autox.team.net>
Sent: Saturday, March 15, 2008 7:42 AM
Subject: [TR] TR4 - TR6 Transmission
> Hello,
>
> I have what I believe is a TR6 Transmission that I would like to use in my
> 3A
> but I note that the rear mount position is about 1/2 to 3/8 " longer than
> the
> 3.
>
> I have heard this discussion before that a plate can be made to adjust for
> the
>> distance.
>
> Has or is there anyone out there who can either provide the details,
> sketch or
> photo of how it was done? Or better is there a supplier of the needed
> plate?
>
> Seems to me that the plate where the transmission mount would be the part
> to
> be adjusted.
>
> Bob
> _______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|