Thanks for the leads. I will look for a part number as I do not see this in
the Moss catalog.
The seat kit I have just received from TRF uses masonite for the backs (as
original) so I am hopeful the clips will still work. My old seat backs have
a tendency to pop loose on long drives, probably from the flexing that
occurs as I squirm in the seat.
This may be due to the age of the masonite & some damage in the area around
some of the small holes in it possibly from a PO who didn't realize you
slide them down to remove (rather than pry like a door panel).
Geo
----- Original Message -----
From: "Brian Induni" <308gtsi@roadrunner.com>
To: <triumphs@autox.team.net>
Sent: Tuesday, February 26, 2008 10:33 PM
Subject: [TR] TR4 Seat Back Hardware
> Geo,
> I replaced my entire 4a interior last fall and the seat backs were one of
> the most frustrating pieces! I found the clips thru TRF and Moss, but
> since
> the new panels were made of thin wood (plywood), these clips were useless.
> I
> ended up using two small chrome screws, one in each top corner, to hold
> the
> panel on. Kind of dress it up too, imho.
>
> Brian
> '67 4a
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|