> I'm installing an ADDCO front anti-roll bar to my 59TR3a. The mounts that
hold> the straight part of the bar in front are SUPPOSED to bolt to the
bumper> brackets. The mount hardware needs to be longitudinal to the car, but
the> bumper brackes angle out so that only the bottom hole will line up with
the> bumper brackets.> > I guess I can make an additional little angle iron
tab for the top hole, or> else weld the bottom part of the hardware to the
bumper brackets, but that's> not very elegant.> > Is someone making an
alternative mount, (Joe Alexander?) or does someone have> a trick solution to
this problem?> > Thanks,> Curt> 59TR3A> 2008 MINI Cooper S> Spec Racer Ford
#11
I made adaptors from steel plate that bolted to the bumper brackets and
allowed the sway bar mounts to be on the straight part of the sway bar.
Although I am saying it myself, they are quite elegant.
John
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|