I'm installing an ADDCO front anti-roll bar to my 59TR3a. The mounts that hold
the straight part of the bar in front are SUPPOSED to bolt to the bumper
brackets. The mount hardware needs to be longitudinal to the car, but the
bumper brackes angle out so that only the bottom hole will line up with the
bumper brackets.
I guess I can make an additional little angle iron tab for the top hole, or
else weld the bottom part of the hardware to the bumper brackets, but that's
not very elegant.
Is someone making an alternative mount, (Joe Alexander?) or does someone have
a trick solution to this problem?
Thanks,
Curt
59TR3A
2008 MINI Cooper S
Spec Racer Ford #11
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|