Hi List,
I have 14" Ford wheels on my TR3A. To my surprise recently I discovered they
are all running close to 0.050' run out. I think this is what is causing the
shimmy in my front end.
I am preparing to cut the center sections loose and reset the off set on my
garage floor while curing the run out at the same time. Has any one had any
experience with this? Does anyone know of a reliable company that can correct
the run out for me?
The only wheel manufacturers I can find use a 0.035 tolerance for their wheels
and I hope to get a lot closer than that.
Best regards,
Tom
_________________________________________________________________
Connect and share in new ways with Windows Live.
http://www.windowslive.com/share.html?ocid=TXT_TAGHM_Wave2_sharelife_012008
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|