Yes, 7/16 x 32 is correct. There are taps to be found - just cruise the
net. Or, if you have a buddy that's handy with the lathe perhaps you
can persuade him to single-point thread one for you using a drilled-out
nut of a similar size.
Dennis
Im thinking about a special shift knob for my TR3 resto. Having
measured
the threaded shaft, I find it to be approx. 7/16x32. This is a size I
never
heard of but I will need to find a tap to make the knob insert. Does
anyone
have any idea what I have here?
Joe Laurito
Central PA Triumph Club
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|