> After pressing new bushings into the lower A-arms, (TR3) you
> are supposed to ream them to fit the trunnion. There was no
> clearance specified though, so how much do I have them
> reamed? I was thinking maybe .001" on a side for .002"
> total clearance, sound about right?
The clearance is built into the pin diameter ... just ream them to the
nominal size. 5/8" as I recall.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|