oops got my genders mixed up and I had my B post mounts made by a
machinist so they may be different than yours but they were copied
from original parts. Rimmers has a parts diagram on their site:
http://www.rimmerbros.co.uk/rimmer/triumph/tr6/hood-frame
scroll down to find it.
Begin forwarded message:
> From: Don Spence <dkspence@telus.net>
> Date: October 31, 2007 1:46:30 PM MDT (CA)
> To: triumphs@autox.team.net
> Cc: motorcarriage@charter.net
> Subject: Re: Triumphs Digest, Vol 1, Issue 308
>
> Wayne
> From Memory, follow the instructions and remove the soft top ( rear
> plate first, then fold the top and remove the three screws from
> each side mount ).
>
> Install the "female" body mounts using the three screws that held
> the soft top to the body door post areas. do NOT fully tighten
> yet. With a helper, place he hard top on to the car sliding the
> "male" pieces into the "female" mounts. Run the two bolts into the
> front of the HT at the windshield header. Leave loose. Run the two
> bolts at the rear of the hard top into the matching threaded holes
> in the rear deck. Tighten all progressively. Done.
>
> The worst thing about it is you will now hear all the rumbles,
> creaks, groans and squeaks that were inaudible in an open car.
>
> Cheers
> Don
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|