Wayne
From Memory, follow the instructions and remove the soft top ( rear
plate first, then fold the top and remove the three screws from each
side mount ).
Install the "female" body mounts using the three screws that held
the soft top to the body door post areas. do NOT fully tighten yet.
With a helper, place he hard top on to the car sliding the "male"
pieces into the "female" mounts. Run the two bolts into the front of
the HT at the windshield header. Leave loose. Run the two bolts at
the rear of the hard top into the matching threaded holes in the rear
deck. Tighten all progressively. Done.
The worst thing about it is you will now hear all the rumbles,
creaks, groans and squeaks that were inaudible in an open car.
Cheers
Don
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|