> I am fitting a new MOSS tachometer cable in the TR3. How far
> into the tachometer drive below the distributer should the cable go?
> Mine only goes about 1/4 inch. I am thinking that it should go
> farther in and perhaps I have a broken piece stuck in mine. Can
> someone tell me how far it goes in? ISTR last time I did this I ended
> up shortening the cable with a hack saw.
> If I do have a broken cable, is there a way to push it out from
> behind?
> Bill Brewer
Hi, Bill. Mo-Ma, who does gauge rebuilding, carefully and clearly warns that
you want to snip the cable off to 1/4 inch before inserting into either the
tach or speedometer. Reason is, the extra length does disaster inside.
Because these cables are made of individual strands of wire, I used a bench
grinder to shorten.
If you do have something stuck inside, you might try a magnet.
Have fun!
Terry Smith, '59 TR3A
New Hampshire
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|