On Friday 17 August 2007 05:48 pm, Ronnie Babbitt wrote:
> Is it possible to remove and replace the hydraulic brake switch located at
> the five way connector on a TR3 with out having to bleed the brake system?
> I was told that if you do not press the brake pedal and quickly swap them
> it can be done with out having to bleed the system.
>
>
>
>
>
>
>
> Ronnie Babbitt
Ronnie,
I am guessing it should work as the pressure gizmo and gravity would prevent
an air bubble from entering. But be sure to shield the area from the small
amount of fluid that will be leaking as you make the switch. Also it is a
tight area to work.
Good luck!
Bob
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|