On Sunday 05 August 2007 04:33 pm, DLylis@aol.com wrote:
> In places where it is difficult/impossible to reach the back side and the
> bolt had to be cut, what is the conventional wisdom in reattaching the rear
> wing?
>
> David Lylis
> 69 TR6 CC26160L
> 60 TR3A TS74461LO
>
>
Dave,
I dont know if this will work for you but I replaced the 3 lower rear caged
nuts that are hidden by removing that panel, removing the nuts and cutting
slots so I could install the speed nuts that are used on a TR4. I re-welded
the panel and the rear fender is now secured similar to a TR4. I have had to
remove the fenders a few times and those 3 bolts just come out as easy as
pie.
Bob
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|