I've forgotten if we found a source of the nuts or not ... was just thinking
that it wouldn't be all that hard to make them yourself. MMC will sell you a
foot of 7/16" square stock for under $4, then all you have to do is drill & tap
it. Easier with a lathe, but not impossible by hand.
And if you pay yourself minimum wage, those nuts shouldn't wind up costing more
than $4-5 each <G>
Randall
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|