Well, It would appear to be that way , but there is no way at all to know
how many revolutions the drive shaft is turning and thus measure the ratio.
To be able to determine the ratio without disassembling the diff, you have
to set up a controlled situation. That is what I was describing. (Apples
and oranges)
Joe
-----Original Message-----
From: triumphs-bounces+spitlist=cox.net@autox.team.net
[mailto:triumphs-bounces+spitlist=cox.net@autox.team.net] On Behalf Of Mark
J. Bradakis
Sent: Saturday, July 21, 2007 5:28 PM
To: Triumph Sports car discussion
Subject: Re: [TR] high engine rpm
> That situation is a whole different issue. In my scenario, I have one
wheel set so that it does
> not turn at all.
Actually what he describes is *exactly* the same - the wheel on dry
pavement does
not turn at all - all the torque goes to the wheel on the ice that
offers no resistance.
mjb.
_______________________________________________
spitlist@cox.net
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|