| To: | Michael Godley <mgodley@tiac.net>, "triumphs@autox.team.net" |
|---|---|
| Subject: | Re: [TR] TR4A Upper Ball Joint Remaoval |
| From: | Greg Perry <rgperry@earthlink.net> |
| Date: | Sun, 1 Jul 2007 05:00:55 -0500 (GMT-05:00) |
I used the open end of a large combination wrench to take up the slack when using the ball joint fork. The wrench is used against the top of the verticle link while the fork is placed on top of the wrench. Greg Perry === This list supported in part by The Vintage Triumph Register === http://www.vtr.org |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Next by Date: | Re: [TR] Jacks for TR2/3/3A/4, Bob Labuz |
|---|---|
| Next by Thread: | Re: [TR] TR4A Upper Ball Joint Remaoval, Bob Labuz |
| Indexes: | [Date] [Thread] [Top] [All Lists] |