> I have not found any indication of the "over/under" orientation of the
> holed section of the arms.
Page G11 of the factory workshop manual (or page 239 of the Bentley
reprint), section 15 paragraph (iii) :
"With the ball pin assembly towards the operator the wishbone flange on the
right overlaps the one on the left. This applies to both left and right
suspension units."
Randall
CONFIDENTIALITY. This electronic mail and any files transmitted with it may
contain information proprietary to NavCom Technology, Inc., or one of its
affiliates, and are intended solely for the use of the individual or entity to
whom they are addressed, shall be maintained in confidence and not disclosed to
third parties without the written consent of the sender. If you are not the
intended recipient or the person responsible for delivering the electronic mail
to the intended recipient, be advised that you have received this electronic
mail in error and that any use, dissemination, forwarding, printing, or copying
of this electronic mail is strictly prohibited. If you have received this
electronic mail in error, please immediately notify the sender by return mail.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|