Here is an exchange with a fellow Green Country Triumph member about the
switch location:
But, back to your original question..
Top to bottom in TS27356 I show:
Panel
Wiper
Side/Head
Bently Manual shows same configuration.
Richard Carney of Bartlesville, OK finished this restoration in'78. He
collected three cars in various
states, was able to restore two, and the car I purchased was his "keeper".
It has the original
wiring harness, now rapidly sheading threads. Though it is not a concours
restoration, I have
yet to find much of anything that is in conflict with the Bentley manual.
I also have a couple of old after market manuals.
Clymer Publications Triumph Service Repair Handbook TR2-TR6 & GT6 1954-1974
(Copyright 1975)
shows same as above.
Glenn's Triumph Repair and Tune-Up Guide (Performance and Mechanical
Specifications TR-2,
TR-3, TR-3B, TR-4, Sport 6, Spitfire, Herald, Herald 1200) (Copyright 1965,
Third Printing March
1968) has a non-physical layout electrical diagram for the TR2-3, so that is
not much help.
There is a physical layout for the Herald 948. At first glance, the center
cluster appears to be
the familiar rounded trapezoid. BUT, there are two additional panel back
lights AND the
top-to-bottom switch configuration is:
Wiper
Panel
Lighting (Side/Head)
This configuration swaps the Panel and Wiper position, but this is for a
different model with a
different center panel.
Does this help or add to the confusion?
All the Best,
-Jim
And, another opinion. . .
Sam and Carol Clark
Green Country Triumphs
TS45355L O
CC82030U O
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|