Hi folks,
I put everything back together and checked the end float (per Haynes) with a
dial indicator and guess what!
Zero end float at either wheel. I mean, not even 0.001. I'm really pulling
and pushing but no movement. Am I doing something wrong here?
I'll order up some shims and get back to you when I have set up the float.
Just one last question. How much grease should I put in the cavity for the
bearing? Normally, when using a grease gun on a nipple, the excess starts to
ooze out someplace but I don't think the excess can go anywhere in this case.
Or I am wrong.
Thanks for all your help.
Regards, Adrian TS 58324
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|