Adrian Jones wrote:
>1. The oil seal to be replaced is still in place:
>
>How to remove it - should I just lever it out with an oil seal remover tool or
>is there a better way.
>
This is what I used:
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=4876
>3. I have the axle assembly lying on the garage floor - I can separate the
>bearing housing from the hub to give a gap of 1/8". Is this normal?
>
As I recall, that sounds normal.
>4. Those six bolts were held in place with tab washers but they were quite
>loose - could that cause the oil leak.
>
Seems unlikely. Were they really loose... or just not very tight?
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.409 / Virus Database: 268.14.10/541 - Release Date: 11/20/2006
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|