> the heater fan does nothing. i took the dash around it off and measured the
> switch. there is one black input i assume to the switch for ground, and
> three green wires for each of the speeds. i'm assuming as you turn it on,
> the fan motor get's more grounded. that is all good. then i found the
> green/grey wire on the fan motor. i grounded it and still no fan. i could
> not find any other wire on the fan motor.
My book shows that the motor has two wires, a green and a pink. The green wire
goes to switched 12v from the fuse block; the pink wire connects to the
green/slate wire at the resistor assembly. Not sure where the resistor assembly
is mounted, but it looks like it's on the blower housing above the motor.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|