the heater fan does nothing. i took the dash around it off and measured the
switch. there is one black input i assume to the switch for ground, and
three green wires for each of the speeds. i'm assuming as you turn it on,
the fan motor get's more grounded. that is all good. then i found the
green/grey wire on the fan motor. i grounded it and still no fan. i could
not find any other wire on the fan motor. can someone suggest further
troubleshooting techniques? if the fan is dead, is there an impedence i can
measure. it's a tight fit there, any suggestions for remove / replace on
the fan? thanks, larry stein
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|