If there are any responses to John's question, please post them on the list,
as I am also installing a new loom in my TR2, and am following his
questions, and any responses, with great interest.
David Gunn
TS3388L
1954 TR2
>From: John Gillis <jgillis@tcd.ie>
>Reply-To: John Gillis <jgillis@tcd.ie>
>To: triumphs@autox.team.net
>Subject: [TR] new loom Q
>Date: Tue, 17 Oct 2006 09:43:17 +0100
>
>Fitting up my new loom to RHD TR2, all going quite well, as always there
>are a few Q's, I appear to have 3 wires on the branch loom to the wiper
>motor, diagram shows 2, I have green, green/black and black (earth), traced
>the other end of the green to an extra wire near the group of greens at the
>fuse box, is this just a different way of including the motor onto the fuse
>circut?. The other issue I have I cannot figure out the route of the branch
>wiring to the wiper motor, in all my books it does not show a clear path
>for this part of the loom, an as it stands it is too short from where it
>exits the firewall with the main loom to reach the wiper motor, my early
>car has the motor on the R/side and being RHD I also have the brake/clutch
>master cylinder to get around. One last one the control box shows tow earth
>wires going to the final connector, there is only 1 coming off the loom,
>and another with a ring connector on it, where does this fit?
>Thanks
>John
>--
>John Gillis
>1954 Triumph TR2
>1991 Kawasaki W650
>Dublin
>IRELAND
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|