I need input from the list on a "tool" that Frank Fisher has machined for
simplifying float height adjustment on ZS carbs. When I had to do mine the
challenge was getting a consistently accurate measurement. I even asked a
carb rebuilder what he used and it was a paper template that comes with the
rebuild kits. So I sent Frank a drawing with measurements based on a
cardboard template I made and here's what he came up with
(http://tinyurl.com/nxq33) I'd appreciate any input or suggestions from the
List as Frank could produce them if there was sufficient interest...or just
do a small run and sell them on eBay! I think this will only work on ZS CDSE
and CD-2SE carbs. If anyone is currently rebuilding their carbs let me know.
Maybe you can be the first to try the prototype.
Input is welcome, encouraged and needed.
Thanks
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.1.406 / Virus Database: 268.12.5/450 - Release Date: 9/18/2006
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|