Hi JIm,
Put the felt side away from the bearings. It will form the seal against the
vertical link holding the stub axle.
Greg Gelhar
1973 TR6
1980 TR8
Osseo, MN
>
> Good morning to all! I am putting the TR6 front rotors back on, after
> receiving them from the shop that resurfaced them and ran into a snag.
The
> "bearing shield" and felt washer are one piece. Does the felt face
towards
> the bearing or in the opposite direction? In other words, when I look at
the
> rear of the rotor, will I see the felt or the steel lip? I am on hold
until
> I sort this out. Bentley's is not clear on this point. Thanks to
> all!..........Jim McArthur @ jrmcarthur@verizon.net
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|