I did this also. I bought the TR4 bar for my 4A from Moss years ago, and
just threaded it through the loops. Fits perfect and works fine; in my
case, no bending of the loops was required, perhaps because the TR4 bar is
not as thick as the TR6 one.
Chris
----- Original Message -----
From: "Darrell Walker" <darrellw@ipns.com>
To: "Anthony Rhodes" <spamiam@comcast.net>
Cc: "tr list" <triumphs@autox.team.net>
Sent: Saturday, June 03, 2006 12:34 PM
Subject: Re: [TR] advice on installing a front swaybar on TR4A
> On Jun 3, 2006, at 11:35 AM, Anthony Rhodes wrote:
>
> > With the tow loops on the front of the stock TR4A radiator shield,
> > I wonder where the bar would fit on a 4A. When you position the
> > bar perfectly horizontal, it wants to sit where the loops are! So,
> > either the loops have to be cut off, or the bar is in FRONT of the
> > loops, or it is UNDER them in some manner, and thereby reducing
> > road clearance.
>
> I just ran mine through the loops. Had to bend them "open" a bit to
> get it in, but then they could go back in place.
>
>
> --
> Darrell Walker
> 66 TR4A IRS CTC67956L
> Vancouver, WA, USA
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|