| To: | spridgets@autox.team.net |
|---|---|
| Subject: | modifying lower link |
| From: | BCAH@aol.com |
| Date: | Mon, 13 Mar 2006 02:31:58 EST |
I was planning on adding an additional grease fitting to the welch plug on the lower link where the fulcrum pin goes.Any hints? Can I pull the welch plug out and put in a new one if I mess it up? Is a copper washer needed? Any drill sizes I should start with? Any thoughts would be appreciated,--------------Bob C |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Fwd: Experience with John Skinner, David Griffiths |
|---|---|
| Next by Date: | TR3B worth, parts, Zach Roberts |
| Previous by Thread: | RE: [FOT] Vintage Gran Prix May 6th & 7th @ Camden NJ, MDunst / Gasket Works USA |
| Next by Thread: | Re: modifying lower link, Timothy H. Collins |
| Indexes: | [Date] [Thread] [Top] [All Lists] |