Curt,
It is fairly easy to install a new liner and piston set. The only critical
measurement is to ensure the liner stands proud of the block per
installation instructions. That ensures a good liner seal. Mine all fit
perfectly so no adjustments were necessary. You get a new set of figure of
eight seals with the kit. IMO it is the easiest and best way to go. Not
sure what current prices are, but if you have a mix of new and used pistons
it is well worth the cost of all new parts.
Pete
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of
CFisher@borgwarner.com
Sent: Tuesday, March 07, 2006 8:27 AM
To: triumphs@autox.team.net
Subject: How hard to fit a big bore kit to a TRactor motor?
Dear list,
I looked over my smoky flaky compression motor closer last night and saw
that only the one piston is new, the other three look like a mixed set of
used ones. Also I have scores in at least one bore. Now I'm thinking about
biting the bullet and buying a new sleeve/piston set.
Am I dreaming to hope that you can just buy the set and install it without a
lot of complex measurments and having things machined to actually fit right?
Is it tough to actually get the sleeves to seal up right, or can a non
engine savvy guy follow the directions and get it to work?
I read through the section on changing a sleeve in the Haynes manual and it
didn't sound too bad.
Thanks,
Curt
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
=== unsubscribe/change address requests to majordomo@autox.team.net
|