On 12/15/05 at 9:10 AM, dorpaul@negia.net (Paul Dorsey) wrote:
> Hey! Would it be a smart thing to apply POR-15 to only a small part of the
> caliper brake PISTON'S (on only the inside of the cup-like bottom) as this
> spot is so prone to rust but yet doesn't touch anything?
At a minimum you'ld have to use one of their high temp formulations.
>
> Is a 24-hour above 50 degrees for POR-15's drying ALWAYS imperative?
It takes considerably longer than that to really cure.
Bill
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|