Hi all,
OK, I'm stumped. How do you remove the stub axle from the housing to
replace the seal. I have tried a gear puller but I can hear the axle
laughing at me as tighten it. I guess the answer is going to be a
press. After 30 years of assembly , these two have grown on each other.
I would try heat but I don't want to damage the bearing.
Is this the common method or is there another method I can try.
--
Mitch Seff
Oceanside, N.Y.
75 TR6 SC
http://www.triumphowners.com/384
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|