Hi Robert:
I see that there is a nice little 120 VAC unit for jewellry sizes on ebay
right now.
http://cgi.ebay.ca/OLYMPIC-HB64-120V-CERAMIC-POTTERY-GLASS-KILN_W0QQitemZ8228
530916QQcategoryZ3099QQrdZ1QQcmdZViewItem
Too small for auto work unfortunately, but perhaps useful for your
application. Mind you, it's not a negligible price as you noted. Of course if
you have a diamond-encrusted anything needing powder-coating that is too large
to fit in a 4"x6" volume, then perhaps $180 isn't a problem. :^)
Cheers,
Mark
________________________________
From: BearTranserv@aol.com [mailto:BearTranserv@aol.com]
Sent: Wed 26/10/2005 5:53 PM
To: Mark Hooper; tr3driver@comcast.net; triumphs@autox.team.net
Subject: Re: Do-it-youself powdercoating oven? (was: Wheel Paint for 76 TR6b
Steel W...
In a message dated 10/26/2005 12:28:57 P.M. Mountain Daylight Time,
mhooper@digiscreen.ca writes:
You might consider buying a used hobbyist pottery kiln.
Mark
I've found these hard to come by around here, and pricey when available. I
only want a small one for some jewelry work. Even Ebay failed me on this.
Robert B. Houston
Texan in New Mexico
63 TR4
73 MG Midget
94 F150
03 Beetle
To model our political system upon speculations of lasting tranquility, is to
calculate on the weaker springs of the human character.
---Alexander Hamilton
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|