>> Another alternative, if you don't mind changing the way they work, is to
>> tap the
>> existing hole for a small setscrew. I fabricated a push rod for the
>> center vent
>> on my TR3A a very long time ago this way (when they were not available
>> new) and
>> it's still on the car. To remove the knob, I have to completely unscrew
>> the
>> setscrew with an Allen (hex) wrench.
>>
>> Randall
Hello, everyone.
I did try this today. So easy.... The tap is 6 - 32, the inset screws are
6-32 3/8. You don't have to redrill the hole at the end of the switch stem,
just tap it, and it all goes into place.
Thanks again, Randall. I upgrade my debt to two cerveza's du jour at the
Triumph Inn.
Terry Smith
'59 TR3A TS 58667
New Hampshire
|