> I am in the category of changing to Superlites
> (from wires) and this spacer idea sounds good to me.
Spacers won't help you, you need longer studs for non-wire wheels.
> Is there a source for the spacers or do I need to have them machined.
Try at your local "custom wheel" shop, they should have them.
> Also, I am a little confused about the rear studs is
> there room to punch out the old stud and pull in the new ones without
> removing the rear hub? IRS Car...
There was on my Stag, but it might be a bit different than the IRS TRs. As
I recall, I had to turn the hub to a specific position to get each stud out,
but there seemed to be enough room for a disc wheel stud in that position.
Don't know for sure though, as I was replacing wire with wire.
Randall
|