Mark Endicott wrote:
>I am in a place where I have all of the stuff needed to cut a piece of steel
>tube for an alternator conversion. Does anybody have the inside measurement
>of the generator bracket that is mounted to the 3/4 block? I am thinking it
>is about 4 inches inside to inside but not sure now that I am at work.
>
I make it 3 5/8" inside to inside... but that is measuring with it in
place so it is hard to get a good look. Might want a second opinion if
someone has one where they can get directly at it.
Geo Hahn
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.322 / Virus Database: 267.3.2 - Release Date: 5/31/2005
|