While it probably wont hurt since vibration isn't quite the problem on half
shafts that it is on drive shafts. A half shaft spins at much less RPM,
at the most it sees is maybe 1500-1700 rpm vs. possibly 5000+ for a drive
shaft. Even at cruising speed a half shaft is turning around 900-1100 RPM.
If you want a "simpler" method you might try some good cable ties, but
the wire will certainly last much longer -
************************************
>Is it wise to use worm drive clamps to secure the rubber gaiters to the
>rear axle shafts of a TR IRS car?
Barry Schwartz (San Diego)
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.11.3 - Release Date: 5/3/2005
|