Hi All
I have a PI TR6. The valve that allows you to set the idle on the manifold
is loose. Is it suppose to be a tight fit, I guess so otherwise air will
leak in all the time. Is it suppose to be bent? The nozzle bit that goes
inside the manifold is on mine about 25 degrees. Is there any sort of O
ring or does it just push into the manifold?
Thanks in advance
George
George Perkins
Farthingdown
Folkestone Road
Dover Kent
CT15 7AB
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.11.2 - Release Date: 02/05/2005
|