Hi Don
I have a set of 13 inch KN Minators and a set of 15 inch Kn Minators, the
13's are located with taper seat nuts, the 15's are located with parallel
shank flanged nuts (Like the Stag alloys use), I have balancing issues with
the 15's and not with the 13's, I think the problem is that the 15's are not
located as well as the 13's, or perhaps the centre hole is not central as
this is what the machines all use to locate the wheel.
Graham.
----- Original Message -----
From: "Don Malling"
Subject: TR6 steel wheel roundness and TRF's KN Minilite replicas
> Does anyone have experience with TRF's KN Minilite Replicas in terms of
roundness issues. The reason
> I ask is that TRF advertises their Panasports as being "rounder" than
anything you can buy. That
> could be interpreted as implying the KN minilite replicas as not quite as
good in the roundness
> category.
>
> Experiences/comments?
>
> Thanks,
>
> Don Malling
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.12 - Release Date: 15/04/2005
|