Thanks John,
I can take it from there.
It's ~30 mm from the trim ring screw to the edge of the body
aperture in my car, so that would put the lever ~30-35mm into
the hole...
Meaning; the body aperture can't easily handle a R380 gearbox
- if the R380 extension is left un-shortened, since the R380
with a TR8/SD1 bell housing positions the lever 42mm rearwards
of the oem TR8 position. And that's somewhere 'in' the hand-
brake lever... :-(
Thanks
and a happy new year to you too,
/Odd
-----Original Message-----
> From: john taylor
> Sent: Monday, December 27, 2004 5:45 PM
> To: Odd@triumphclub.se
> Subject: shifter
>
> Hi,
> Ok. With the shifter i neutral measured from the back of the
> square part of the shifter to the rear screw hole for the trim
> ring for the rubber sealing gater is 65mm or 2.5 inch.
>
> Will this work or shall I take the gater off?
> Gott nytt ar
> John
|