In a message dated 4/5/2004 4:01:10 PM Eastern Daylight Time,
MotoPsyche@aol.com writes:
I appreciate the advice, Gene. Any idea what the stud length should be as
measured from the face of the hub?
Don't know the final length, but the steel wheel studs should be shortened
by 'approximately 5/16" ' (according to several Triumph Service Bulletins) to
properly fit the wire wheel hubs.
--Andy Mace
*Mrs Irrelevant: Oh, is it a jet?
*Man: Well, no ... It's not so much of a jet, it's more your, er,
Triumph Herald engine with wings.
-- Cut-price Airlines Sketch, Monty Python's Flying Circus (22)
|