I have some inner sills and floor pans that I acquired from one of the
major US suppliers in the mid-1980s. My TR2 project has been dormant for
many years, but I recall that at least one of the sills had the mounting
bracket installed in the wrong location. You might investigate this as
a possibility. Don't assume that the replacement part is correct.
> -----Original Message-----
> From: Doug
> Subject: TR3A floors and sill replacement
>
> Then I removed the inner sill and replaced it with a new one. When trying
> to line up the four frame bolt holes I need to move the sill ahead about
0.3
> inches so that the floor, sill and outrigger holes line up. But according
> to my measurements and gut feeling this puts the sill too far ahead and
the
> back inner fender mount to the sill would be out by this amount.
|