re: Metal cutting advice needed - non LBC

["john matthews" <john__matthews@hotmail.com>]

I recently bought one of these.

http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=46681

You don't say what gauge metal you're cutting, but if it's fairly thin sheet 
you could lay out your hole and start it with a holesaw then finish with the 
electric shear. Might come in handy for bodywork too....

Cheers,

John Matthews
'61 Herald
'63 TR 4

_________________________________________________________________
Get reliable dial-up Internet access now with our limited-time introductory 
offer.  http://join.msn.com/?page=dept/dialup