In a message dated 12/23/03 4:10:30 PM Eastern Standard Time,
pboldtrix@juno.com writes:
<< This will involve cutting 6" diameter holes
in the top of each of 10 stainless steel vacuums. >>
Take the tops to a metal fab shop. They can use a plasma cutter and produce
smooth holes in no time. Ask them if they have a template for a 6" hole, if
not look around for something round ( pipe ) .
A few dollars spent now will save lots of time ( 10 units, probably 1 hr of
shop time, ~ 40.00 ), sometimes it is not worth fighting grinders, tinsnips,
saw blades and such.
Harold
|