Spec for GT6 engine (which I assume is the same) is .0018" to .0020"
cheers
Scott
>From: "J.Cole" <cole.jw@comcast.net>
>
>I am putting new rod and main bearings in my 1972 TR6. I would like to
>check
>bearing clearance with Plastigage. I have the Bentley manual, but don't see
>a
>spec. listed anywhere for the acceptable clearance of the rod and main
>bearings. Does anyone know the specs? Thanks in advance!
_________________________________________________________________
Add photos to your messages with MSN 8. Get 2 months FREE*.
|