They'll work an ANY bent up sheet metal.
Those are the most common way body shops
pull out sheet metal. Once you're done 'pulling'
the pins are simply ground off. Buy A LOT
of the pins. On a badly crinkled fender....
you could use as many as 20 or more per square
foot, especially on curved panels.
Paul Tegler
ptegler@cablespeed.com
www.teglerizer.com
----- Original Message -----
From: "Paul Dorsey" <dorpaul@negia.net>
To: "triu autox" <triumphs@autox.team.net>
Sent: Sunday, October 26, 2003 4:20 PM
Subject: new welder?
> Hey,
> Has anybody heard or seen anything like the following:
>
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=2355775399&ssPageName=ADME
> :B:SS:US:1
> And do you think it would work on a TR3?
>
> Thanks, Paul
|